Extenders

USB 1.1 Extender over Ethernet up to 150ft

Note:: Ethernet patch cable sold separately.

The maximum distance for a USB cable is typically 15 feet. After that, the USB signal begins to fade and reliability becomes an issue. USB cables with repeaters are one solution, but the USB-EXTENDER can carry your signal far beyond the scope of a booster. They use the twisted pairs of a single Ethernet cable to achieve extraordinary distances. Using this extender set, you can increase your distance to up to 150 feet using Cat5E cables. It is compatible with Windows and iOS platforms, so it can be used with most PC and Mac computers. No software installation is required.

Rated for USB 1.0 and 1.1 standards and specifications, the USB-EXTENDER is best suited for printers, keyboards, and mice but may not be appropriate for external hard drives, cameras, or charging and syncing mobile devices. It is also not recommended for use with wireless devices such as USB WiFi adapters. These extenders are small and require no power source, so they can be easily stashed anywhere. The single Ethernet cable is also easily run through conduit for a simple in-wall solution.

USB 2.0 Cat5e/Cat6 Extender Via Single RJ45 Ethernet

This USB extender allows you to conquer 150Ft USB length limitation, Connect your USB peripherals and important equipment without regard for proximity. The USB Extender uses Cat5, Cat5e, or Cat6 RJ/45 cable to extend the range of your USB devices by up to 150Ft feet. The units compact design allows for easy placement behind equipment or around corners. Its simple: One side of the USB Extender attaches to your USB peripheral, the other to the USB port on your PC. The three aforementioned cable options connect them in the middle. Gone are the days of trying to fit all your peripherals onto one desk. The USB Extender simplest way to spread your equipment out.

ADAPTER IR SENDER 1.5M

<!-- features -->

• IR Transmitters- Receivers- and Adapters are compatible with Vanco’s HDMI Matrixes- Splitters- Switchers- and Extenders that are enabled with Super IR technology
• HDMI IR Adapter Allows for IR Control over any Vanco HDMI Cable
• Extends IR Signals more than 100m/328ft
• Supports Dual Band IR
• HDMI IR Adapter is IR or CEC Configurable

Techlogix Networx TL-IR-CC IR Coupling cable 

How many times have you had to output an IR signal from your control system to the input of an HDMI extender? In the CI world, this is an extremely common requirement. For years, the solution has been to tape the IR emitter from the control system to the IR receiver of the extender. Sometimes, the IR receiver is designed to rest on a surface and features a rounded, aesthetically pleasing appearance, but this makes attaching the IR emitter with a flat base difficult. Then, you have a wad of tape in the middle of two thin wires that turn that expensive installation into an unsightly mess. This is where the TL-IR-CC comes in.

The TechLogix TL-IR-CC allows direct IR to IR connections between devices. The IR IN (TRS) connector is compatible with an IR input which provides +5V DC to the tip of the connector. The TL-IR-CC allows a direct connection between the IR output of a third-party control system and a Techlogix extender. The TL-IR-CC will also allow daisy-chaining IR signals between Techlogix extenders.

Manhattan 4K HDMI Repeater / Extender

Active, Distances up to 40 m (131 ft.), Simple One-Piece Solution, Black

Easily extend your HDMI signal

The Manhattan 4K HDMI Repeater extends the range of an HDMI signal by decoding and regenerating it at 4K@60Hz resolution from virtually any HDMI source (PlayStation, Xbox, Blu-ray player, satellite receiver, digital recorder, etc.) using existing HDMI cables. Designed for plug-and-play installation, the Repeater boosts weak signals to reduce or eliminate picture noise, degradation, or sparkles on an HD display or projector. An additional USB port is included to boost power to video sources that need to travel longer distances.

Flexible Solution for Many A/V Applications

The Manhattan 4K HDMI Repeater is ideal for trade shows, classrooms, home theater, conference rooms, business office and retail applications. It offers the flexibility of placing a high-definition display or projector at up to 40 m (131 ft.) from the HDMI source. For best performance, situate this Repeater near the middle of the distance (15 to 20 m [49 to 65 ft.]) and use high-quality HDMI cables (longer distances and inferior cables may degrade performance) by Manhattan.

Quality Construction and Easy Installation

HDCP compliant with HDMI, HDCP 2.2 and DVI 1.0, this HDMI Repeater is tested to guarantee performance and reliability. It installs quickly without additional software, hardware or power sources (in most cases).

Extend your composite RCA signal by up to 1000ft with this balun.

It transmits the signal using CAT5 or CAT6 Ethernet cable to another balun, and eliminates the need for long composite cables.

3.5mm Stereo Audio Extender Over Cat5e/Cat6 250ft

3.5mm Stereo Audio Ove Cat5e / Cat6, Stereo Balun Extender, Stereo Balun Extender Over Ethernet.