Fluke Pro3000 Analog Tone and Probe Kit

The Pro3000 Analog Tone and Probe is your best choice for toning and tracing wire on non-active networks, and specifically for identifying individual pairs with SmartTone technology. Angled bed-of-nails clips allow easy access to individual wires, and the RJ-11 connector is ideal for use on telephone jacks. The large loud speaker on the network probe allows you to hear through drywall, wood or other enclosures to find wires quickly and easily.

• Tone and trace wire on non-active networks SmartToneTM technology provides five distinct tones for exact pair identification
• Sends loud tone up to 10 miles (16 kilometers) on most cables
• Loud speaker on Probe makes the tone easier to hear through drywall, wood, and other enclosures
• Angled bed-of-nails clips allow easy access to individual pairs
• RJ-11 connector is ideal for use on telephone jacks Attach nylon pouch (included in kit) to your belt for easy transport

Pro3000 Analog Toner Specifications:

• User interface Slide switch selects Continuity or Tone Mode
• Push button switch selects SOLID, ALT or OFF
• Tone mode LED
• Continuity/Polarity LED
• Solid Frequency 1000 Hz nominal
• Alternating Frequency 1000/1500 Hz nominal
• Over Voltage Protection 60 Vdc in Toner/Polarity Mode
• Output Power in Tone Mode 8 dbm into 600 ohms
• Output Voltage Level in
• Continuity Mode
• 8 Vdc with fresh battery
• Battery 9V alkaline
• Temperature Operating: -20Ëš C to 60Ëš C, Storage: -40Ëš C to 70Ëš C
• Case dimensions 2.7 in. x 2.4 in. x 1.4 in. (6.9 cm x 6.1 cm x 3.6 cm)

Pro3000 Analog Probe specifications:

• User interface ON/OFF pushbutton
• Volume dial
• Replaceable tip
• 3.5 mm earphone jack
• Battery 9V alkaline
• Temperature Operating: -20Ëš C to 60Ëš C, Storage: -40Ëš C to 70Ëš C
• Case dimensions 9.8 in. x 1.6 in. x 1.3 in. (24.9 cm x 4.1 cm x 3.3 cm)