HDMI IR Repeater Kit up to 300 Feet
Using this IR repeater kit, you can extend your IR signal through an HDMI cable up to 300 feet. You can conveniently control source devices hidden away in cabinets or closets, or even in separate rooms.
How it Works
The transmitter plugs into one of the adapters, which is connected to your source device. The receiver plugs into the second adapter, which is connected to your TV or display. A single HDMI cable connects the two adapters.
NextGen Invisible Multi-Room Remote Extender
Make any normal remote work anywhere in your house. Works through doors, walls, and floors! Simple Setup and ease of use.
There are two separate frequencies for these remote extenders: 418 and 433MHz. This is for cases where you might want to install one upstairs and one downstairs, or your neighbor also has one and you want to make sure the signals are not interfering with each other.
From $48.99 - $52.99
Techlogix Networx TL-A8O-20W-IR IR Control Kit for the Mixer/Amp
The TL-A8O-20W-IR is a convenient remote control kit for the TechLogix TL-A8O-20W mixer/amplifier. Simply connect the included IR receiver into the IR port on the rear of the mixer/amplifier and use the wireless remote to control the unit.
Techlogix Networx TL-IR-CC IR coupling cable for TechLogix twisted pair extenders
How many times have you had to output an IR signal from your control system to the input of an HDMI extender? In the CI world, this is an extremely common requirement. For years, the solution has been to tape the IR emitter from the control system to the IR receiver of the extender. Sometimes, the IR receiver is designed to rest on a surface and features a rounded, aesthetically pleasing appearance, but this makes attaching the IR emitter with a flat base difficult. Then, you have a wad of tape in the middle of two thin wires that turn that expensive installation into an unsightly mess. This is where the TL-IR-CC comes in.
The TechLogix TL-IR-CC allows direct IR to IR connections between devices. The IR IN (TRS) connector is compatible with an IR input which provides +5V DC to the tip of the connector. The TL-IR-CC allows direct connection between the IR output of a third-party control system and a Techlogix extender. The TL-IR-CC will also allow daisy-chaining IR signals between Techlogix extenders.
Vanco 280700 HDMI IR Control Kit
The Vanco 280700 HDMI IR Control Kit contains everything you need to add IR control to your setup using any existing HDMI cable. Simply plug the adapters onto an HDMI cable and attach the IR transmitter and receiver to extend the IR signal up to 328 feet. IR or CEC configurable with the flip of a switch.