Your Cart

Free Shipping on Orders > $74.99 - *Some Exclusions May Apply

expand/collapse
(704) 979-7100 (0)
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle
  • Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle

Current AudioAMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker Bundle

SKU#: AMP1270&6BCS80FL

UPC#:

60 Day Money Back Guarantee

100% Secure Shopping

SKU#: AMP1270&6BCS80FL

UPC#:
$1,613.85

SKU#: AMP1270&6BCS80FL

UPC#:

Same Day Shipping likely on orders placed in the next 00 hours 00 minutes 00 seconds.

Califonia Warning 65

California Prop 65 Warning

×
For CA Residents Only.
California Proposition 65 Warning

Proposition 65, officially the Safe Drinking Water and Toxic Enforcement Act of 1986, is a law that requires warnings be provided to California consumers when they might be exposed to chemicals identified by California as causing cancer or reproductive toxicity. The warnings are intended to help California consumers make informed decisions about their exposures to these chemicals from the products they use. The California Office of Environmental Health Hazard Assessment (OEHHA) administers the Proposition 65 program and publishes the listed chemicals, which includes more that 850 chemicals. In August 2016, OEHHA adopted new regulations, effective on August 30, 2018, which change the information required in Proposition 65 warnings.

• WARNING: Some cable, plastic, and metal products may contain chemicals known to the state of CA to cause cancer, birth defects, or other reproductive harm.

For further information, please visit www.P65Warnings.ca.gov

  • Description+
  • Note: This product has been discontinued.

    AMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker w/FastLoc Grille

    8” 2-Way, In-Ceiling, Coaxial, Infinite Baffle Loudspeaker

    The BCS80FL is a competitively priced full-range Ceiling Loudspeaker that introduces the customer to the possibilities of whole house audio for every room.

    It incorporates a Talc Filled Polypropylene woofer with a butyl rubber surround and fixed polycarbonate dome Ferrofluid cooled tweeter.

    Even in this competitive package our speaker provides exceptional natural sound for both foreground and background applications.

    The Infinite Baffle design makes it the ideal choice for typical application in open beam attic or enclosed ceilings.

    The FastLoc™ grill patent no. 8,422,722, is a feature found only at Current Audio. Our design has allowed for the smallest exposed plastic bezel in the industry, truly making it disappear into the mounting surface. The FastLoc™ grille's unique patent pending mechanism allows for a quick installation and removal of the grill while securely fastening it in place to all types of mounting surfaces. Due to the unique design the grill will conform to uneven surfaces including popcorn, heavy textured and uneven ceilings. While our competitors have chosen to utilize magnets in their

    designs thus requiring the use of a steel grill that will rust our design allows us to use corrosion and rust resistant aluminum.

    6 Zone, 12 Channel Amplifier

    D-Force describes the latest digital technology in amplifiers by Current Audio. The D-Force amplifiers generate the equivalent analog output for speakers by using a modulated audio signal rather than the traditional digital to analog conversion. The amp is a Class D configuration (D does not stand for 'digital' but merely refers to the next letter after Class C). It does exhibit a digital-like output because the outputs are generated by turning the signal completely ON and OFF.

     

  • Features+
  • AMP1270 Features

    Dual Power Mode - Input power is switchable from 110VAC to 220VAC.

    3 Prong Plug - Grounded input power for Safety.

    Master Power Switch - Rear panel switch to cut power for service or hook-up.

    Multi-Stage Protection - Each pair of channels/zones is individually protected with internal circuitry and is indicated on the front bi-color LEDs. The amp will shut down a bad zone if it senses a short or is overdriven. ONLY the channels that are affected will turn Off and indicates by the LED turning from blue to red thus pointing to the channel in distress. The remaining zones will run unaffected and continue to provide sound without shutting down all zones.

    AUX, Global and/or Individual Inputs – One input signal can be universally distributed to all zones or the user can individually dedicate one or more zones to have a unique separate input. The other zones will still play the global input.

    Gain Adjustments – There is a global gain control that sets the maximum level to all zones. In addition, each zone has its own separate gain control to allow the user to customize each zone to match the acoustics of that room. This also sets the maximum loudness of each room.

    Installer Friendly Connections – Each speaker channel has pull off plugs to allow the user to make wire connections up to #14 gauge with positive screw down terminals. The IEC power cord can be disconnected at the amp for easy service. All inputs are made by easy connect gold plated RCA plugs.

    Bridging – If more power is required for perhaps an outside area, two channels may be combined (Bridged) to provide 140 watts at 8 ohms. This is accomplished simply by a selector switch at each zone. CAUTION: Turn power off when making change and always maintain an 8 ohm load when in the Bridge mode.

    Rack Mount – packed with each amp is an accessory pack that include brackets allowing the amp to be rack mountable. This is accomplished by attaching the rack ears with the 4 included screws.

    Power Mode – Power is toggled ON/OFF by the front power switch and is indicated buy the corresponding LED. It can also be triggered ON/OFF by a 12 VDC signal on the rear 3.5mm Trigger in jack. Front Power button must be in standby mode to operate trigger. LED must be red. The tip of the plug is (+).

  • Specs+
  • BCS80FL

    Driver 8” Talc Filled Polypropylene Cone with Butyl Rubber Surround
    Tweeter Fixed 5/8” (16mm) Polycarbonate Dome Tweeter, Ferrofluid Cooled
    Crossover Actual Crossover Network
    Frequency Response 50Hz - 19.5kHz
    Impedance 8 Ohms
    Power Handling 5 - 60 Watts
    SPL 88.5 dB 1W/1m
    Diameter X Depth 11 1/2” (292mm) x 3 3/8” (85.7mm)
    Retrofit Cutout Diameter 9 3/4” (247mm)
    FastLoc Grille Diameter 11 13/16” (300mm)
    Bracket Type NC8CB

    AMP1270

    Continuous Power Output (All Channels Driven) 70 Watts RMS at 4 ohms; 50 Watts at 8 ohms
    Bridged Power Output (All Channels Driven)

    140 Watts per channel RMS at 8 ohms

    Caution: Maintain an 8 ohm load in the bridged mode

    Standby Power < 1 watt
    Power Consumption 1100 watts
    Input Sensitivity/Impedance 500mv /20,000 ohms
    Signal to Noise Ratio 95 db
    Frequency Response 20 Hz to 20 kHz
    Total Harmonic Distortion 0.1% THD 20 Hz to 20 kHz
    Length X Depth X Width 17” (431.8mm) x 4” (101.6mm) x 13” (330.2mm) (32lbs.)

  • Reviews+

Note: This product has been discontinued.

AMP1270 6 Zone 12 Channel 70 Watts Per Channel Amplifier plus 6 pairs BCS80FL 8" In-ceiling Contractor Series Speaker w/FastLoc Grille

8” 2-Way, In-Ceiling, Coaxial, Infinite Baffle Loudspeaker

The BCS80FL is a competitively priced full-range Ceiling Loudspeaker that introduces the customer to the possibilities of whole house audio for every room.

It incorporates a Talc Filled Polypropylene woofer with a butyl rubber surround and fixed polycarbonate dome Ferrofluid cooled tweeter.

Even in this competitive package our speaker provides exceptional natural sound for both foreground and background applications.

The Infinite Baffle design makes it the ideal choice for typical application in open beam attic or enclosed ceilings.

The FastLoc™ grill patent no. 8,422,722, is a feature found only at Current Audio. Our design has allowed for the smallest exposed plastic bezel in the industry, truly making it disappear into the mounting surface. The FastLoc™ grille's unique patent pending mechanism allows for a quick installation and removal of the grill while securely fastening it in place to all types of mounting surfaces. Due to the unique design the grill will conform to uneven surfaces including popcorn, heavy textured and uneven ceilings. While our competitors have chosen to utilize magnets in their

designs thus requiring the use of a steel grill that will rust our design allows us to use corrosion and rust resistant aluminum.

6 Zone, 12 Channel Amplifier

D-Force describes the latest digital technology in amplifiers by Current Audio. The D-Force amplifiers generate the equivalent analog output for speakers by using a modulated audio signal rather than the traditional digital to analog conversion. The amp is a Class D configuration (D does not stand for 'digital' but merely refers to the next letter after Class C). It does exhibit a digital-like output because the outputs are generated by turning the signal completely ON and OFF.

 

AMP1270 Features

Dual Power Mode - Input power is switchable from 110VAC to 220VAC.

3 Prong Plug - Grounded input power for Safety.

Master Power Switch - Rear panel switch to cut power for service or hook-up.

Multi-Stage Protection - Each pair of channels/zones is individually protected with internal circuitry and is indicated on the front bi-color LEDs. The amp will shut down a bad zone if it senses a short or is overdriven. ONLY the channels that are affected will turn Off and indicates by the LED turning from blue to red thus pointing to the channel in distress. The remaining zones will run unaffected and continue to provide sound without shutting down all zones.

AUX, Global and/or Individual Inputs – One input signal can be universally distributed to all zones or the user can individually dedicate one or more zones to have a unique separate input. The other zones will still play the global input.

Gain Adjustments – There is a global gain control that sets the maximum level to all zones. In addition, each zone has its own separate gain control to allow the user to customize each zone to match the acoustics of that room. This also sets the maximum loudness of each room.

Installer Friendly Connections – Each speaker channel has pull off plugs to allow the user to make wire connections up to #14 gauge with positive screw down terminals. The IEC power cord can be disconnected at the amp for easy service. All inputs are made by easy connect gold plated RCA plugs.

Bridging – If more power is required for perhaps an outside area, two channels may be combined (Bridged) to provide 140 watts at 8 ohms. This is accomplished simply by a selector switch at each zone. CAUTION: Turn power off when making change and always maintain an 8 ohm load when in the Bridge mode.

Rack Mount – packed with each amp is an accessory pack that include brackets allowing the amp to be rack mountable. This is accomplished by attaching the rack ears with the 4 included screws.

Power Mode – Power is toggled ON/OFF by the front power switch and is indicated buy the corresponding LED. It can also be triggered ON/OFF by a 12 VDC signal on the rear 3.5mm Trigger in jack. Front Power button must be in standby mode to operate trigger. LED must be red. The tip of the plug is (+).

BCS80FL

Driver 8” Talc Filled Polypropylene Cone with Butyl Rubber Surround
Tweeter Fixed 5/8” (16mm) Polycarbonate Dome Tweeter, Ferrofluid Cooled
Crossover Actual Crossover Network
Frequency Response 50Hz - 19.5kHz
Impedance 8 Ohms
Power Handling 5 - 60 Watts
SPL 88.5 dB 1W/1m
Diameter X Depth 11 1/2” (292mm) x 3 3/8” (85.7mm)
Retrofit Cutout Diameter 9 3/4” (247mm)
FastLoc Grille Diameter 11 13/16” (300mm)
Bracket Type NC8CB

AMP1270

Continuous Power Output (All Channels Driven) 70 Watts RMS at 4 ohms; 50 Watts at 8 ohms
Bridged Power Output (All Channels Driven)

140 Watts per channel RMS at 8 ohms

Caution: Maintain an 8 ohm load in the bridged mode

Standby Power < 1 watt
Power Consumption 1100 watts
Input Sensitivity/Impedance 500mv /20,000 ohms
Signal to Noise Ratio 95 db
Frequency Response 20 Hz to 20 kHz
Total Harmonic Distortion 0.1% THD 20 Hz to 20 kHz
Length X Depth X Width 17” (431.8mm) x 4” (101.6mm) x 13” (330.2mm) (32lbs.)

Open Google Reviews for our website ×